(North American Specification model specific) DEFENDER 90 SOFT TOP OR HARD TOP (soft top or hard top must be specified at time of ordering). ROOF RACK, REAR DOUBLE LADDER w/ BACKING PLATES, CROSSBAR PAIR w/ INTEGRATED CLAMPS & ALL STAINLESS STEEL MOUNTING HARDWARE.
These kits are revised tributes to the long since discontinued Safety Devices/Genuine Land Rover components that were a Land Rover dealer option commonly referred to as a "Safari Kit". One full length 7" tall profile roof rack "basket w/ two rear light/lamp tabs. Two external roll cage crossbars with integrated clamps. One rear double ladder with backing plates.
All required stainless steel mounting hardware to install. All fabricated components are sandblasted to remove impurities prior to coating, zinc primer base coated and finished in semi-gloss black powder coat. My racks are made using a different construction method of notching rather than the crimping/smashing/flattening method used in the originals as I think my method is much cleaner looking and ultimately stronger. My crossbars are made with a larger overall diameter tubing and with a bend radius to match the rear double ladder and the windshield roll cage hoop (please note some of the images may reflect a older radius design) rather than the rolled radius design of the originals. I weld flange nuts to the rear double ladder backing plates to assist in installing the rear double ladder assembly to the vehicle as well as to the underside of the mount tabs on the crossbars and to the rear double ladder to make mounting the roof rack as clean and as simple as possible.My clamps are made from machined steel rather then cast aluminum like the originals as they were considered the weak point of the original kits as they were prone to cracking. Since my clamps are made from the steel, I integrate them to the crossbars with I think is much clean looking and ultimately stronger. All my tubing bend components are C. Mandrel bent, all tubing joints are pneumatic/hydraulic notched, all seam joints are sleeved, welded and polished. My backing plates are C. Laser cut as are the mounting brackets on the rear ladder which are also C. All my mounting tabs are stamped.
All my components are fixture "jig" clamped during welding to ensure accuracy and consistency and to mitigate warping during the welding process. All tubing is cleaned and polished prior to welding. All welds are gas M. Welded (and I'm damn good at what I do).
This rack will mount to all Land Rover N. Defender 90 soft top or hard top models. The item "SAFETY DEVICE STYLES LAND ROVER DEFENDER 90 NAS ROOF RACK BASKET LADDER CROSSBAR" is in sale since Wednesday, July 17, 2019. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Racks".
The seller is "chasechopshop" and is located in Temecula, California. This item can be shipped to United States.